CNC after-calculation with a clean setpoint-actual comparison
CNC after-calculation is only helpful if target and actual times describe the same. CNC Kalkulator combines the shared computing level with feedback from BDE, MES, ERP or a controlled manual recording. Order, component revision, batch size, machine and time type must be clearly assigned. Set-up time, machine duration, test time and entire job duration are considered separately so that a visible deviation can result in a technically recoverable statement.
Depending on the depth of detail of the source, the comparison shows differences per part of time or operation. Production management and work preparation evaluate the cause. Tool breakage, missing material or a one-time fault do not automatically speak against the calculation. Recurring deviations in comparable parts and the same machine can indicate an inappropriate profile, a missing side-time or a too rough process assumption.
Confirmed findings flow into subsequent calculations in a controlled manner. A master data value can be corrected, a rule can be adjusted for a clear scope of validity or a documented factor used. Changes remain versioned and require the intended release. Their effect should be checked for appropriate reference cases. If a change proves to be inappropriate, it can be withdrawn in a comprehensible manner.
CNC Kalkulator does not change its rules unnoticed and promises no firm accuracy for every order. Weakly maintained feedback, changing process conditions or small numbers of cases limit the significance. A possible model training would be a separate process to be evaluated. The benefit lies in a closed learning cycle: deviations are visible, causes are confirmed professionally and improvements are specifically released for the tested part and process area.
Follow-up calculations from real production data
Deviations will be made for concrete improvement rather than for a flat-rate correction.
Make times comparable
Equipment, machine and test times are only compared with unambiguous assignment.
Evaluate Causes
Specialists separate faults, individual cases, data errors and systematic deviations.
Control changes
Adjustments shall be versioned, released and checked for appropriate reference cases.


