Calculate the rotational speed of the circular saw
The blade diameter D in mm and the cutting speed vc in m/min determine the speed n in 1/min. Conversely, the cutting speed at the blade circumference is determined by diameter and known speed: a sheet with 250 mm diameter at 100 1/min runs at π × 250 × 100 ÷ 1000 = 78,5 m/min.
For metal, the cutting speed is given in m/min, for woodworking machines usually in m/s. For the comparison, the value is divided into m/min by 60.
n = 1000 × vc γ (π × D); vf = n × z × fz
Calculate feed speed during sawing
The number of teeth z and the feed per tooth fz in mm give the feed speed vf in mm/min at the speed. As with milling, each tooth carries off a chip of the thickness fz; more teeth or a higher speed increase the feed with the same spandick.
vf = n × z × fz
Example with 250 mm sheet diameter
With assumed 250 mm blade diameter and 80 m/min cutting speed, the result is approximately 101.86 1/min. With 80 teeth and 0.02 mm tooth feed, a feed of approximately 162.97 mm/min follows.
The values exclusively illustrate the formulas. They are not a recommendation for material, sheet, tooth shape or machine. Permissible speed, tool data and manufacturer approval must be checked before an application.
Check the permitted speed itself
The calculator does not limit the speed to a machine-specific maximum value. Compare the result itself with the permissible limits of machine, saw blade and voltage. If it is above, select a released lower speed.
With the selection "Speed" you can calculate this speed and check the resulting cutting speed and feed. A nominal value must not be displayed as a value actually reached.
Cutting speed and feed during band sawing
A band saw has no rotating blade diameter to which the circular saw formula can be applied directly. Band speed, tooth division, feed control and cross section determine the process in common. This calculator therefore does not provide a band saw feed.
For a time estimation, a suitable measured surface performance can be used with the cross-section in the saw time calculator. There, too, tape speed in m/min and cutting power in cm²/min remain separate inputs or sizes.
Questions and answers
How do you calculate the cutting speed when sawing?
From leaf diameter and speed: vc = π × D × n ÷ 1000. A circular saw blade with 250 mm diameter at 100 1/min has 78.5 m/min cutting speed. Conversely, n = 1000 × vc namely (π × D).
Does the side calculate the feed for a band saw?
No. The formula vf = n × z × fz describes here a circular saw with rotating sheet. For a band saw suitable manufacturer or operating data are required.
Where do cutting speed and tooth feed come from?
From the data released for tool, material and machine or from tested own process data. The pre-occupied figures show only one calculation path.


