What does rubbing mean?
Fine machining of a pre-drilled borehole with small dimensions for dimensional accuracy and surface quality.
Rubbing is the finishing of a pre-drilled hole with a friction bar. With a small dimension and a low cutting speed, a precise drilling with a good surface is created, typical for fitting holes in H7.
Rubbing in production and calculation
The pre-drilling must be smaller than the finished dimension by the friction measure; too much overburden overburdens the rubble, too little lets it rub instead of cutting. In the calculation, each grated bore creates its own operation with tool change.
Go to topic: Calculate friction measurement
- Tolerance H7: Dimensions of hole H7 per nominal dimension.


