The ratio of drilling depth to diameter is decisive. Up to about 3 × d a normal drill bit is sufficient, up to 5 × d is removed and the feed is reduced, above it a deep hole drill with inner coolant supply is to be provided. The calculator adds the time for the retreats.
Formulas
Tiefenverhältnis = L ÷ dFirst classification
Definitely tool choice and strategy.
n = (vc × 1000) ÷ (π × d)Speed
As with any bore from the diameter.
t = L ÷ (n × f)Pure cutting time
No retreats and access routes.
Rückzüge = aufgerundet(L ÷ Zustellung) − 1Steps taken to de-machine
Every retreat creates time without cutting.
Deep drilling costs disproportionate
From three to five times the diameter, time and process risk increase significantly faster than the drilling depth. If you notice this first in the production, it has not calculated in the offer.
Questions and answers
When is a hole considered to be deep?
The limit is usual at three to five times the drill diameter. From there the chip removal worsens, the heat remains in the bore and the guidance of the drill becomes critical.
How much time does it take to clear?
Each retreat drives the drill from the borehole and again. At 60 mm depth, 16 mm delivery and 6,000 mm/min withdrawal, three additional withdrawals are created – the time surcharge is indicated in the calculator and is often in the range of pure cutting time.
What changes in feed?
At greater depths, feed is usually reduced by 10 to 30 percent to avoid chipping and drill breakage, with manufacturer's specifications containing depth factors.
When is a deep hole drill worth it?
From about 5 × d, at the latest from 8 × d. A solid carbide deep hole drill with internal cooling often drills through without cutting and, despite higher tool costs per component, is cheaper because time and risk of breakage are reduced.
What should be observed for crossholes and oblique exits?
Both produce interrupted cut and one-sided load. Here the feed is reduced before the breakthrough; in case of strongly slanting exit, a pre-processing of the exit surface or a guide hole is necessary.


